System Memory - Procom BST1M Series User Manual

1
BST1M Series User's Manual
4
Integrated I/O
This motherboard has a full set of integrated I/O
ports mounted on the board. They include PS/2 key-
board and mouse ports, two USB ports, a RJ45 LAN
connector, a parallel port, a serial port, a VGA port, a
game/MIDI port and Line Out, Line In and Mic au-
dio jacks.
There are also pin connectors on the board for o p-
tional port brackets for the separately-purchased Ir-
DA port module. If you install an infrared port, the
second serial port is disabled.
Onboard Peripheral Interfaces
There are connectors for two IDE channels and a
floppy disk drive interface on the motherboard. The
board supports two floppy disk drives. The two IDE
channels support two devices each for a total of four
devices. All IDE data transfer modes are supported
including all PIO modes and Ultra DMA33 and 66
modes for a maximum data transfer rate of 66MB
per second. The motherboard comes with one floppy
and one IDE cable. The IDE cable supports all IDE
modes and devices.

System Memory

The motherboard has two sockets for 168-pin 3.3V
non-buffered SDRAM DIMM memory modules.
You can use PC100 or PC133 memory. PC66 mem-
ory is not supported. You can install any combination
of DIMMs from 16MB to 256MB for a maximum
system memory of 512MB.
Embedded 2D/3D Video Display
The SiS 630 series chipset has an embedded 64-bit
AGP video display. The chipset supports 2D display
graphics up to 1600 x 1200 in 8-bit color at a refresh
rate of 85Hz.