Make Electrical Connection - KitchenAid RANGE HOOD LINER with INTERNAL BLOWER Installation And Use Instructions Manual

4. ■ If using the rear electrical knockout, drill a 1 " (3.0 cm)
dia. hole through the wall at the location shown.
hood support
centerline
(front view)
of hood
Hood size
36" (91.4 cm)
■ If using the top electrical knockout, drill a 1 " (3.0 cm)
dia. hole through the hood support at the location shown.
hood support
(top view)
right rear hood
mounting hole
5. Remove the filters. Use two hands to remove filter. Push tab
back to release the locking pin, pull down and forward. Set
filter aside. Repeat with other filter(s).
6. Remove the terminal box cover located behind the right hand
filter.
7. Install UL- or CSA-listed strain relief in hood liner so that
screws can be tightened.
8
A
A
14 " (36.0 cm)
2" (5.1 cm)
1 "
(3.8 cm)
2" (5.1 cm)
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Run power supply cable to the hood electrical hole according
to the National Electrical Code or CSA Standards and local
codes and ordinances. There must be enough power supply
cable from the fused disconnect (or circuit breaker) box to
make the connection in the hood's electrical terminal box.
3. Remove the four mounting screws from the parts bag. It is
recommended they be placed by the holes in the hood liner
support for quick access.
Use two or more people to move and install range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, feed the wiring through the strain
relief while lifting the hood liner into place.
5. Insert the screws through the support and thread into the
hood liner holes. Tighten screws securely.

Make Electrical Connection

WARNING
Electrical Shock Hazard
WARNING
Excessive Weight Hazard