Loading Paper Into The Lct - Konica Minolta bizhub C652 User Manual

8.1 Paper

Loading paper into the LCT

The same procedures can be used to load paper into the Large capacity unit LU-301 and LU-204.
The following procedure describes how to load paper into Large capacity unit LU-301.
0
1
2
d
To configure paper settings:
Press [Basic] ö [Paper].
bizhub C652/C652DS/C552/C552DS/C452
Downloaded From ManualsPrinter.com Manuals
To change the paper size, contact your service representative.
Open the upper door.
NOTICE
Be careful not to touch the surface of the paper take-up roller with
your hand.
Lift up the paper take-up roller, and then load the paper into the
tray.
% Load the paper into the tray so that the side of the paper to be
printed on (the side facing up when the package was
unwrapped) faces down.
% Do not load so many sheets of paper that the top of the stack
is higher than the mark.
% Do not load the LCT with paper of a size other than that
previously specified.
% If paper is curled, flatten it before loading it.
% If special paper is loaded, the paper type must be specified.
% Load letterhead paper so that the side to be printed on faces
up.
Reference
8
8-7