FUNAI HT2-M200 Owner's Manual page 52

Hide thumbs Also See for HT2-M200:
Table of Contents

Advertisement

Problem
The unit does not respond to the
remote control.
Buttons do not work or the unit
stops responding.
The unit does not respond to
some operating commands
during playback.
The unit cannot read BD / DVD/
CD.
Angle does not switch.
Playback does not start when the
title is selected.
The password for rating level has
been forgotten.
Cannot connect to the network.
Cannot connect to the network
while my PC is connected to the
network.
The capacity of the SD card
decreased.
Cannot use the BD-Live function
or download of data does not
perform properly.
Cannot play back BD-video (BD-
ROM Profile 2.0).
Cannot play back Internet radio.
Cannot play back the Internet
radio station in my favourite list.
The audio of Internet radio
station interrupted.
The quality of Internet radio
audio is poor or noise occurs
during playback of Internet
station.
Radio reception is poor.
Note
• Some functions are not available in specific modes, but this is not a malfunction. Read the description in this
manual for details on correct operations.
• Some functions are prohibited on some discs.
52
OTHERS
- Aim the remote control directly at infrared sensor window on the front panel.
- Reduce the distance to infrared sensor window.
- Replace the batteries in the remote control.
- Re-insert the batteries with their polarities (+ / - signs) as indicated.
- To completely reset the unit, press and hold [STANDBY/ON Q] on the front
panel for 10 seconds to shut down the unit or unplug the mains cable from the
AC outlet for 15-20 seconds.
- Operations may not be permitted by the disc.
Refer to the instructions of the disc.
- Condensation? (Let sit 1 or 2 hours)
- You are attempting to playback a disc other than one with one of the Logos on
page 16.
- Wipe the dirt off the disc or replace the disc.
- The angle cannot be switched for BD / DVD which do not contain multiple
angles. In some cases multiple angles are only recorded for specific scenes.
- Check the settings in "Parental" menu.
- Enter the default password "4737", then your forgotten password will be cleared.
- Check if the LAN cable connection is properly made.
- Turn on the modem or broadband router.
- Check the network settings.
- Check if the broadband router and/or modem is correctly connected.
- Check the "BD-Live Setting".
- Check the content of your Internet service contract to see if your Internet Service
Provider prevents multiple terminals connecting at the same time.
- Data may be written to the SD card when a BD-video that supports the virtual
package is used and an SD card is in the slot.
- Insert an SD card with enough space(1GB or more).
- Check if an SD card is correctly inserted.
- Make sure the write-protect switch on the SD card is not enabled.
- Insert an SD card(1GB or more) which is formatted on this unit.
- Some discs with BD-Live function require memory when playing back the content.
- Do not remove the card during playback.
- Make sure the write-protect switch on the SD card is not enabled.
- Check if the network connection is properly made.
- Check the firewall setting of the modem or router.
- For some stations, playback is not available on this unit.
- The station is busy or no longer active.
- Try again later.
- vTuner server, station or the Internet connection is busy.
- The bit rate of the station is high.
- The bit rate of the station is low.
- If the signal is too weak, adjust the antenna or connect an external antenna for
better reception.
- Increase the distance between this unit and your TV or VCR.
- Tune in to the correct frequency.
- Place the antenna further away from any equipment that may be causing the
interference.
Solution
EN

Advertisement

Table of Contents
loading

Table of Contents