Table of Contents
Advertisement
Category
Video
Still Mode
Note for "HDMI Video Resolution" and "Component Output"
• Even if you set "HDMI Video Resolution" setting to "Auto", when this unit is connected to a DVI compatible display
devices with an HDMI-DVI cable, 480p/576p signal will be output.
• Video and audio signals may be distorted temporarily when switching to / from the HDMI output mode.
• You cannot change the video resolution during Blu-ray Disc playback. To change the resolution, stop playback.
• In order to get natural and high quality film reproduction of 24-frame film material, use an HDMI cable (High Speed
HDMI cable is recommended) and select "Auto" if the connected TV is compatible with 1080p24 frame input.
• Even if the connected TV is compatible with 1080p24 frame input and you set "HDMI Video Resolution" setting to
"Auto", when the contents of the disc are not compatible for 1080p24 frame, 1080p60 frame will be output.
• If the picture is not output properly to the TV because of "HDMI Video Resolution" or "Component Output" setting,
press and hold [PLAY B] on the front panel for more than 5 seconds. Both settings will be reset to the default
automatically.
• For video resolution of the component output, you can only select the video resolution which is currently output
from HDMI OUT jack or "480i/576i" if HDMI cable is connected.
• If you change "HDMI Video Resolution" setting or set the setting to "Auto", the video resolution for the component
output will be switched to "480i/576i".
• If you play back copy-protected DVD-video, 480p/576p signal will be output from COMPONENT VIDEO OUT jacks,
when "Component Output" setting is set to "720p" or "1080i".
• With some copy-protected BD-video, the video image may only be output from HDMI OUT jack.
• Refer also to your TV's manual.
38
FUNCTION SETUP
Menus / Options
Auto
Field
Frame
Description
Adjusts picture resolution and quality
in still mode.
"Auto":
Automatically selects the best
resolution setting ("Frame" or "Field")
based on the data characteristics of
the pictures.
"Field":
Stabilises the pictures, although the
picture quality may become coarse
due to the limited amount of data.
Select "Field" when the pictures are
still unstable even if "Auto" is selected.
"Frame":
Displays relatively motionless pictures
in higher resolution. "Frame" improves
the picture quality, although it may
unstabilise the pictures due to
alternate output of 2-field data.
• An individual picture on the TV
screen is called "Frame", which
consists of two separate images
called "Field". Some pictures may be
blurred at the auto setting in "Still
Mode" setting due to their data
characteristics.
EN
Advertisement
Table of Contents
