Table of Contents
Advertisement
Safety Instructions
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
The important note and rating are located on the rear or
bottom of the cabinet.
Laser Safety
This unit employs a laser. Only qualified service personnel
should remove the cover or attempt to service this unit,
due to the possibility of eye injury.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE.
CAUTION: CLASS 2 LASER RADIATION WHEN OPEN
DO NOT STARE INTO THE BEAM
LOCATION: INSIDE, NEAR THE BD MECHANISM
Power Supply
The power supply is connected and the unit is live when
the mains cable is plugged into a 220 - 240 V~, 50 Hz AC
outlet. To operate the unit, press [STANDBY/ON Q].
WARNING: LIVE PARTS INSIDE.
DO NOT REMOVE ANY SCREWS.
Caution
1 Do not attempt to open the cabinet. There are no
user serviceable parts inside. Refer all servicing to
qualified service personnel.
2
Slots and openings in the cabinet at the sides and
underneath are provided for ventilation. To ensure
reliable operation and to protect the unit from
overheating, these openings must not be blocked or
covered.
Avoid installation in enclosed spaces such as
bookcases unless suitable ventilation is provided.
3
Keep the unit away from radiators and other heat
sources.
4
Avoid use near strong magnetic fields.
2
INTRODUCTION
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
"dangerous voltage" within the product's
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
The symbol for CLASS II (Double Insulation)
5
Do not push objects of any kind into the unit through
the cabinet slots or openings as they could touch
electrically live parts or short circuit parts resulting in a
fire or electric shock.
6
To prevent fire or shock hazard, do not expose this
apparatus to dripping or splashing, no objects filled
with liquids, such as vases, should be placed on the
apparatus.
7
Do not stand the unit vertically. Use the unit in a
horizontal (flat) position only.
8
This product is in Stand-by mode when turned off
while the mains cable is connected.
To completely shut down the unit, you must
disconnect the mains cable.
9
Do not place any combustible objects on the device
(candles, etc.).
10 Before moving the unit, be sure to remove any discs
and unplug the mains cable from the AC outlet.
11 Disconnect the mains plug to switch off when the unit
becomes faulty or not in use.
12 The mains plug shall remain readily operable.
13 Read the manual instructions to ensure correct and
safe installation and interconnection of the unit in
multimedia systems.
14 This apparatus should not be placed in a built-in
installation such as a bookcase or rack unless proper
ventilation is provided. Make sure to leave a space of
20cm or more around this apparatus.
EN
Advertisement
Table of Contents
