Connecting Portable Media Player; Connecting Fm Radio Antenna; Network Connection With Lan - FUNAI HT2-M200 Owner's Manual

Connecting Portable Media Player

STANDBY/ON
OPEN/CLOSE
Connect a 3.5mm stereo audio cable(not supplied) to
the MP3 LINE-IN jack on this unit and the headphone
jack on your portable media player.
No supplied cables are used in this connection:
Please purchase the necessary cables at your local
store.
Note
• To playback the audio from your portable media
player, refer to "Play from Portable Media Player" on
page 32.

Connecting FM Radio Antenna

1
Connect the supplied FM wire antenna to the FM
ANT 75Ω jack on this unit.
2
Extend the FM antenna and fix its ends to the wall
for optimum reception.
Note
• For better FM stereo reception, connect an external
FM antenna (not supplied).
• Place the antenna away from your TV, VCR or other
radiation source to prevent any unwanted
interference.
• For FM radio playback, refer to "Radio Operations" on
page 32.
14
CONNECTIONS

Network Connection with LAN

By connecting this unit to the Internet, you can update the
software via the Internet or access the BD-Live and vTuner
VOLUME STOP PLAY SOURCE
service.
SD CARD MP3 LINE-IN
MP3 LINE-IN
Networking equipment
MP3
No supplied cables are used in this connection:
Please purchase the necessary cables at your local
store.
Caution
• Do not insert any cable other than a LAN cable to the
LAN terminal to avoid damaging the unit.
Note
FM
ANT
75
• After connecting a LAN cable, set up necessary
network settings. (For the network setup, refer to
"Network Connection" on pages 46-48.)
• For more information about the software update,
refer to "Network Update" on page 49.
• For more information about BD-Live, refer to
"Enjoying BD-Live Discs with Internet" on pages 27.
• For more information about vTuner, refer to "Enjoying
Internet Radio with vTuner" on page 33.
• If your network equipment (modem, etc.) does not
have broadband router functions, connect a
broadband router.
• If your network equipment (modem, etc.) has
broadband router functions but there is no vacant
port, use a hub.
• For a broadband router, use a router which supports
10BASE-T/100BASE-TX.
• Do not connect your PC directly to the LAN terminal
of this unit.
• Please purchase shielded LAN cables at your local
store and use them when you connect to network
equipment.
Hub or broadband router
(modem, etc.)
LAN
LAN cable
Internet
WAN LAN
5 4 3 2 1
LAN cable
EN