Table of Contents
Advertisement
System Audio Control
When you set your TV to output the audio from the 5.1ch
speakers through this unit, you can control the volume
level or mute the audio using TV's remote control. (For
more details, refer to the owner's manual of your TV.)
Note
• For external input mode, "One Touch Play" is not
available.
• Volume level will be displayed on the front panel
display.
• If you change the speaker setting of your TV to
output the audio from TV's speaker, 5.1ch speakers
will be muted. (To restore the volume, use the
remote control of this unit.)
• When you turn this unit into standby mode, TV's
speaker will be activated automatically.
• Depending on the connected TV, two device names
("FUNAI BD" and "Audio System") may be displayed
in the device list of TV's menu screen. To select this
unit, please select "FUNAI BD".
Network Connection
A "Custom"
[SETUP]
Set up the network connection settings in order to use
BD-Live, vTuner service or network update function.
Connection Test
After you made IP address / DNS settings or when a LAN
cable is connected, always perform the connection test to
check if the connection is correctly made.
1
In stop mode, press [SETUP].
2
Use [K / L] to select
3
Use [K / L] to select "Others", then press
[ENTER].
4
Use [K / L] to select "Network Connection",
then press [ENTER].
5
Use [K / L] to select "Connection Test", then
press [ENTER].
Connection test will start automatically and the test result
will appear right after the connection test finishes.
• "Testing... " : The test is in progress.
• "Pass"
: Connection test is successfully completed.
• "Fail"
: Connection test failed.
Check the connection settings.
46
FUNCTION SETUP
A "Others"
A "Network Connection"
, then press [ENTER].
[ENTER]
Press
to go to the list of network status
confirmation screen.
Others
Connection Test
IP Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
then press 'ENTER'.
6
Press [ENTER] to go back to the previous
screen, or press [SETUP] to exit.
Note
• If the connection test passes, you are ready to use
BD-Live, vTuner service or network update function
using the Internet without making any extra settings.
• If the connection test fails, you may need to change
the MAC address settings on your router. You can
check the MAC address of this unit on
"Enable(Custom)" screen.
• "Connection Test" is not available when "Disable" is
selected in "Network Connection".
Enable(Easy)
Network settings are set to the following settings initially.
(In most cases, you can connect to the Internet without
making any changes to the default settings.)
- IP Address Setting
- DNS Setting
- Proxy Setting
- Connection Speed
- BD-Live Setting
If you want to set the network settings back to the default
settings as above (except "BD-Live Setting"), follow the
procedure below.
1
Follow steps 1 to 4 in "Connection Test" on
page 46.
2
Use [K / L] to select "Enable(Easy)", then press
[ENTER].
• The unit will start the connection test automatically
and the test result will appear right after the test
finishes.
• After the connection test finishes, press
go to network status confirmation screen.
3
Press [ENTER] to activate the network settings
and set the network connection automatically.
Press [SETUP] to exit.
Note
• The setting of "BD-Live Setting" will not be set back
to the default, even if you follow the procedure.
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Auto(DHCP)
Auto(DHCP)
Do Not Use
Auto
Allow
[ENTER]
to
EN
Advertisement
Table of Contents
