Removing And Replacing The Metal Flip Shield - Motorola V551 Service Manual

Disassembly

Removing and Replacing the Metal Flip Shield

26
1. Remove the battery cover, battery, SIM card, antenna, rear housing, and
transceiver board assembly, flip assembly and the front flip cover as described
in the procedures.
2. Using a small screw driver, gently pry the metal flip shield off of the flip
assembly, exposing the rubber gasket.
3. Remove the rubber gasket.
Metal Shield
Flip Assembly
Rubber Gasket
Figure 14. Removing the Metal Flip Shield
4. To replace, align the rubber gasket onto the flip assembly and press in place.
5. Align the metal shield over the gasket and snap it in place.
6. Replace the flip front cover, flip assembly, transceiver board assembly, rear
housing, antenna, SIM card, battery, and battery cover as described in the
procedures.
September 28, 2004
V551 GSM
(Pry Here)
(Pry Here)
6809490A38-O