Mercedes-Benz SL Operator's Manual page 551

Do not use hot water and do not wash the
X
vehicle in direct sunlight.
Use a soft sponge to clean.
X
Use a mild cleaning agent, such as a car
X
shampoo approved by Mercedes-Benz.
Thoroughly hose down the vehicle with a
X
gentle jet of water.
Do not point the water jet directly towards
X
the air inlet.
Use plenty of water and rinse out the
X
sponge frequently.
Rinse the vehicle with clean water and dry
X
thoroughly with a chamois.
Do not let the cleaning agent dry on the
X
paintwork.
When using the vehicle in winter, remove all
traces of road salt deposits carefully and as
soon as possible.
Power washers
G WARNING
The water jet from a circular jet nozzle (dirt
blasters) can cause invisible exterior damage
to the tires or chassis components.
Components damaged in this way may fail
unexpectedly. There is a risk of an accident.
Do not use power washers with circular jet
nozzles to clean the vehicle. Have damaged
tires or chassis components replaced
immediately.
! Always maintain a distance of at least
11.8 in (30 cm) between the vehicle and the
power washer nozzle. Information about
the correct distance is available from the
equipment manufacturer.
Move the power washer nozzle around
when cleaning your vehicle.
Do not aim directly at any of the following:
tires
R
door gaps, roof gaps, joints, etc.
R
electrical components
R
battery
R
connectors
R
lights
R
seals
R
trim
R
ventilation slots
R
Damaged seals or electrical components
can lead to leaks or failures.
! Vehicles with HANDS-FREE ACCESS: if a
SmartKey with KEYLESS-GO is within the
detection range of the KEYLESS-GO
antenna, the following situations could lead
to the unintentional opening of the trunk
lid:
using a car wash
R
using a power washer
R
Make sure that the SmartKey is at least
6.5 ft (2 m) away from the vehicle.
Cleaning the paintwork
! Do not affix:
stickers
R
films
R
magnetic plates or similar items
R
to painted surfaces. You could otherwise
damage the paintwork.
Scratches, corrosive deposits, areas affected
by corrosion and damage caused by
inadequate care cannot always be completely
repaired. In such cases, visit a qualified
specialist workshop.
Remove dirt immediately, where possible,
X
while avoiding rubbing too hard.
Soak insect remains with insect remover
X
and rinse off the treated areas afterwards.
Soak bird droppings with water and rinse
X
off the treated areas afterwards.
Remove coolant, brake fluid, tree resin,
X
oils, fuels and greases by rubbing gently
with a cloth soaked in petroleum ether or
lighter fluid.
Use tar remover to remove tar stains.
X
Use silicone remover to remove wax.
X
Care
549
Z