Mercedes-Benz SL Operator's Manual page 375

may not be displayed on the map, even if
the symbol display is switched on.
To exit the menu: press the k back
X
button.
Selecting map information
Map information in the display
During route guidance, you can have map
information shown at the bottom edge of the
display.
To show the menu: press W the COMAND
X
controller.
Select Navi Navi in the main function bar by
X
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Map Settings Map Settings
X
confirm.
The map settings menu appears.
Select Text Information On Map Text Information On Map
X
press W to confirm.
A # dot indicates the current setting.
Select Current Street Current Street,
X
coordinates coordinates or None None
confirm.
To exit the menu: slide XVY the COMAND
X
controller.
Road display
Road names or numbers, e.g. for
:
highways
and press W to
and
Geo- Geo-
and press W to
Geo-coordinate display
Current height above average sea level
:
(rounded to the nearest 10 m)
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
During the "Move map" function, you will see
the geo-coordinates of the crosshair position.
Height display : and number of satellites
used ? are not displayed.
Display switched off
Current map orientation
:
While moving the map, you will see additional
data, depending on the crosshair position, if
the digital map supports this data. A street
name, for example, can be shown here
( page 370).
Y
Coordinates on the map
To show the menu: press W the COMAND
X
controller.
Navigation
373
Z