Mercedes-Benz SL Operator's Manual page 334

Navigation
332
If the vehicle is not on a digitized road, the
following is displayed:
the linear distance to the destination
R
the direction to the destination
R
the Off Mapped Road Off Mapped Road
R
Option 2 – route guidance is already
active: if route guidance is already active, a
prompt will appear asking whether you wish
to terminate the currently active route
guidance.
Select Yes Yes or
X
If you select Yes, COMAND will stop route Yes
guidance and start route calculation for the
new destination.
If you select No, COMAND will continue No
with the active route guidance.
i
Route calculation takes a certain amount
of time. The time depends on the distance
from the destination, for example.
COMAND calculates the route using the
digital map data.
The calculated route can differ from the
ideal route, for example because of
incomplete map data. Please also refer to
the notes about the digital map
( page 380).
Y
Entering and saving your home address
You can either enter your home address for
the first time (option 1) or edit a previously
stored home address (option 2).
Option 1: enter the address, e.g. a city,
X
street and house number (
Once you have entered the address, select
X
Save Save in the address entry menu by turning
cVd and sliding ZVÆ the COMAND
controller and press W to confirm.
Select Save as "My Address" Save as "My Address"
X
W to confirm.
COMAND stores your home address under
the My Address My Address
memory.
message
No No and press W to confirm.
page 327).
Y
and press
entry in the destination
Option 2: proceed as described under
X
"Option 1".
A prompt appears asking whether the
current home address should be
overwritten.
Select Yes Yes and press W to confirm.
X
After selecting Yes Yes, the
Procedure/Successful Procedure/Successful
appears.
Selecting a destination from the
destination memory (e.g. My address)
Introduction
The destination memory always contains an
entry named "My Address". You may wish to
assign your home address to this entry, for
example ( page 332), and select it for route
Y
guidance. This entry is always located at the
top of the list in the destination memory.
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination Destination
X
system menu bar by turning cVd the
COMAND controller and pressing W to
confirm.
Select From Memory From Memory
X
confirm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Saving Saving
message
in the navigation
and press W to