Control Panel; System Cooling - Supero SUPERSERVER 1026T-URF4+ User Manual

S S
UPER ERVER 1026T-URF4+ User's Manual
Figure 6-1. Chassis: Front and Rear Views
Power Supplies
Mouse/Keyboard Ports
6-2

Control Panel

The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System In-
terface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3

System Cooling

The SC119 chassis contains four counter-rotating fans. Each fan unit is actually
made up of two fans joined back-to-back, which rotate in opposite directions. This
counter-rotating action generates exceptional airfl ow and works to dampen vibration
levels. An air shroud is also included in the server.
The SC119 chassis provides an additional open fan housing, where an additional
system fan may be added for optimal cooling.
SATA Drive Bays (8)
USB Ports PCI Expansion Slots
6-2
Control Panel