Fargo DTC4500 User Manual page 101

© 2011 HID Global Corporation
Troubleshooting with the Error Message Table
Error Message
# 45
No Flip Module
installed
# 48
Check Lam Power
# 52
Lam Generic Error
# 53
Lam Card Jam
# 63
Lam Tag Error
DTC4500 Card Printer/Encoder User Guide
Cause
nd
Request to print on 2
card, but no Flipper is installed.
Lam is connected but not
powered.
Laminator firmware error
A jam occurred somewhere
between the Printer and the
Laminator
There is no material loaded in
the Laminator
Solution
side of If a Flipper Module is present,
ensure that the Print Both Sides
option in the Printer Driver is set
correctly.
Install a Flipper module.
Power off the Printer, power the
Laminator, and then power on
the Printer.
A damaged Flipper board, E-
Card board, or EEPROM could
potentially result in this same
error.
Cycle power and try again.
If this problem persists call for
technical assistance.
Open covers and clear the
obstruction/jam
Load material into the
Laminator
All rights reserved
L001444 Rev1.1
101