Connecting The Headlight And Hand Warmer Wire To The Engine; Filling The Engine With Oil - Toro Power Max Heavy Duty 1128 OHXE 38803 Operator's Manual

Figure 14
1. Short rod
4. Insert the front end of the rod into the opening in
the back of the chute gear cover until it slides into the
chute gear (Figure 15).
Figure 15
5. Align the holes in the nested ends of the rods and
insert 2 carriage bolts (in the loose parts bag) through
the short rod from the left side of the machine (from
the operating position).
6. Insert the cable clip that supports the deflector cable
onto the forward carriage bolt, and secure the carriage
bolts with locknuts from the loose parts bag (Figure
16).
g018657
Figure 16
1. Cable clip
g018656
2. Long chute control rod
2. Deflector cable
7. Hold the blue trigger cap down and rotate the Quick
Stick in a circle to ensure that the chute and deflector
operate smoothly.
5
Connecting the Headlight
and Hand Warmer Wire to the
Engine
No Parts Required
Procedure
Plug one connector into the starter wire and another into
the ground (Figure 17).
Note: The pig tails are color-coded.
1. Starter wire connector
6

Filling the Engine with Oil

No Parts Required
Procedure
Your machine comes with oil in the engine crankcase.
Note: Before starting the engine, check the oil level and
add oil if necessary.
11
Figure 17
2. Ground connector