Replacing The Drive Belts; Replacing The Headlight Bulb - Toro Power Max Heavy Duty 1128 OHXE 38803 Operator's Manual

Note: The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 62).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.

Replacing the Drive Belts

If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.

Replacing the Headlight Bulb

Use a GE 892 16W halogen light bulb. Do not touch the
bulb with your hands or allow dirt or moisture to come into
contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 63).
2. Turn the base of the bulb counterclockwise until it
stops (Figure 64).
3. Remove the bulb straight out from the back of the
headlight (Figure 65).
Figure 63
Figure 64
Figure 65
4. Insert a new bulb into the back of the headlight (Figure
66).
5. Turn the base of the bulb clockwise until it is snug
(Figure 67).
6. Insert the wire connector straight into the back of the
headlight until it is securely in place (Figure 68).
27
Figure 66
Figure 67
Figure 68