Table of Contents
Advertisement
the front of the machine on the pavement. Repeat if
necessary until a stream of snow comes out the discharge
chute.
•
If you cannot unclog the discharge chute by bumping
the front of the machine, stop the engine, wait for
all moving parts to stop, and use the cleanout tool;
never use your hand.
•
If a shield, safety device, or decal is damaged, illegible, or
lost, repair or replace it before beginning operation.
•
Do not smoke while handling gasoline.
•
Do not use the machine on a roof.
•
Do not touch the engine while it is running or soon after
it has stopped because the engine may be hot enough to
cause a burn.
•
Perform only those maintenance instructions described in
this manual. Before performing any maintenance, service,
or adjustment, stop the engine, remove the key, and
disconnect the wire from the spark plug. If major repairs
are ever needed, contact your Authorized Service Dealer.
•
Do not change the governor settings on the engine.
•
When storing the machine for more than 30 days, drain
the fuel from the fuel tank to prevent a potential hazard.
Store fuel in an approved fuel container. Remove the key
from the ignition switch before storing the machine.
•
Purchase only genuine Toro replacement parts and
accessories.
Safety and Instructional
Decals
Important: Safety and instruction decals are located
near areas of potential danger. Replace damaged decals.
Reorder part no. 112-6633
1. Fast
2. Forward speeds
1. Cutting dismemberment, impeller and cutting
dismemberment, auger hazards—keep bystanders a safe
distance from the snowthrower.
4
106-4525
3. Slow
4. Reverse speeds
107-3040
Hide quick links:
Advertisement
Table of Contents
