Product Overview - Toro Power Max Heavy Duty 1128 OHXE 38803 Operator's Manual

Serial no. 315000001 and up

Hide thumbs

Table of Contents

1. Start the engine; refer to Starting the Engine (page 15).

2. Move the speed selector to Position R1; refer to

Operating the Speed Selector (page 18).

3. Squeeze the left hand (traction) lever to the hand-grip

(Figure 20).

Figure 20

The machine should move rearward. If the machine

does not move or moves forward, complete the

following:

A. Release the traction lever and stop the engine.

B. Disconnect the trunnion from the speed selector

lever (Figure 11).

C. Turn the trunnion downward (clockwise) on the

speed control rod (Figure 11).

D. Connect the trunnion to the speed selector lever

(Figure 11).

4. Release the traction lever.

5. Move the speed selector to the Position 1; refer to

Operating the Speed Selector (page 18).

6. Squeeze the left hand (traction) lever to the hand-grip

(Figure 20).

The machine should move forward. If the machine

does not move or moves rearward, complete the

following:

A. Release the traction lever and stop the engine.

B. Disconnect the trunnion from the speed selector

lever (Figure 11).

C. Turn the trunnion upward (counterclockwise) on

the speed control rod (Figure 11).

D. Connect the trunnion to the speed selector lever

(Figure 11).

7. If you made any adjustments, repeat this procedure

until no adjustments are required.

Important: If the machine moves when the traction

lever is in the released position, check the traction cable

(refer to Checking and Adjusting the Traction Cable) or

take the machine to an Authorized Service Dealer for

service.