Advantech PCM-9590 User Manual page 37

First / Second / Third / Other Boot Drive
Floppy
LS120
Hard Disk
CDROM
ZIP
USB-FDD
USB-ZIP
USB-CDROM
USB-HDD
LAN
Disabled
Swap Floppy Drive
This item enables users to swap floppy "A" and "B" identified without change
hardware cable connection.
Boot Up Floppy Seek
When enabled, the BIOS will seek the floppy "A" drive one time.
Boot Up NumLock Status
This item enables users to activate the Number Lock function upon system boot.
Typematic Rate Setting
This item enables users to set the two typematic controls items.
This field controls the speed at
– Typematic Rate (Chars/Sec)
This item controls the speed at system registers repeated keystrokes.
Eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
– Typematic Delay (Msec)
This item sets the time interval for displaying the first and second characters.
Four delay rate options are 250, 500, 750 and 1000.
Security Option
– System
System can not boot and can not access to Setup page if the correct pass-
word is not entered at the prompt.
– Setup
System will boot, but access to Setup if the correct password is not entered
at the prompt. (Default value)
MPS Version Control for OS
This item sets the operating system multiprocessor support version.
OS Select For DRAM > 64M
Select OS2 only if system is running OS/2 operation system with greater than 64
MB of RAM on the system.
Select boot device priority by Floppy.
Select boot device priority by LS120.
Select boot device priority by Hard Disk.
Select boot device priority by CDROM.
Select boot device priority by ZIP.
Select boot device priority by USB-FDD.
Select boot device priority by USB-ZIP.
Select boot device priority by USB-CDROM.
Select boot device priority by USB-HDD.
Select boot device priority by LAN.
Disable this boot function.
[Disabled]
[Disabled]
[Disabled]
[Setup]
[1.4]
[Non-OS2]
29 PCM-9590 User Manual