Optional Mmb-84 Flush Mount Bracket - Standard Horizon Eclipse GX1300 Owner's Manual

6.2.2 Optional MMB-84 Flush Mount Bracket

1. To assist in flush mounting, a template has been included. Use this
template to assess the mounting location.
2. Use the template to mark the location where the rectangular hole is to
be cut. Confirm the space behind the dash or panel is deep enough to
accommodate the transceiver (at least 5.5" (14 cm) deep).
There should be at least 0.5" (1.3 cm) between the transceiver's heat
sink and any wiring, cables or structures.
3. Cut out the rectangular hole and insert the transceiver.
4. Fasten the brackets to the sides of the transceiver with the lock washer
nut combination, so that the mounting screw base faces the mounting
surface.
5. Turn the adjusting screw to adjust the tension so that the transceiver is
tight against the mounting surface.
Bracket
Lock-washer nut combination
GX1300
MMB-84 Flush Mount Installation
Adjusting Screw
Page 13