Inmarsat LandPhone User Manual page 15

3. Loosen the wing nuts holding the U-bolts to the pole,
as indicated in the diagram below, and move the antenna
to the estimated azimuth. Use a compass to assist you in
pointing the antenna.
4. Re-tighten the wing nuts once you have positioned the antenna.
Connecting the antenna cable
To connect the cable to the antenna:
1. Connect the large connector on the antenna cable to the antenna,
and hand tighten.
2. Stick the rubber tape supplied to the top of the connector. Stretch
it and wind it clockwise down the connector. Each turn should half
overlap the previous turn. After you have wound the tape down
approximately 3.5 inches (10cm), reverse the direction and wind the
tape back towards the top of the connector. Continue until all the tape
is used up.
16
Installing your LandPhone
Antenna
connector