Panasonic AG-CPD20P Operating Instructions Manual page 83

Administrator Setup
Page 3
GPO1, GPO2, GPO3 Signal
Use this function to select the output signal from GPO1,
GPO2, and GPO3.
GPO1, 2: OFF, REC, ERROR, REC+ERROR
GPO3: OFF, REC
Init Audio Out (Play)
Use this function to set Audio Out used when the power is
on.
ON : All audio channels are output.
LAST : See footnote.
OFF : All audio channels are not output.
Play Mode
Use this function to turn all valid files starting in order
from the oldest file on four SDHC Memory Cards into a
virtual file for playback.
SINGLE : Normal playback for playing back files one at
a time.
RELAY : Plays back multiple files as one single
file without the need for further operation.
Playback pauses upon reaching the end of the
large virtual file (the most recently recorded
file). Playback operation is the same as for
normal playback.
Notes:
• Slow playback of a virtual file that contains intermittent
recording files will revert to normal playback speed at the
start of an intermittent recording file. Slow playback is not
restored for subsequent normal recording files.
• Quick replay starts playback 7 seconds prior to current
location.
• A large virtual file consists of multiple files and video
and sound may be momentarily interrupted in playback
between files.
*
1 Applies the setting in effect when power was last turned off.
Unless power is turned off properly, the operating state may not
be saved correctly.
(continued)
*
1
Skip Target
Use this function to set the skip location when the [Skip
back] or [Skip forward] button is pressed.
Trigger / Marker
Pressing of the skip-buttons jumps to the trigger position (one
per file) at which recording began, or to a bookmark position,
whichever found earlier. However, no trigger position can
exist in automatically divided files.
YES: Jumping with the skip-buttons enabled
NO: Jumping with the skip-buttons disabled
Head of File
Use this function to move to the beginning of a file with the
skip-button operation.
YES: Jumping with the skip-buttons enabled
NO: Jumping with the skip-buttons disabled
Notes:
• When both [Trigger/Marker] and [Head of File] are set
to "YES", playback will restart from the first trigger or
bookmark that appears or restarts from the beginning of
the file.
• [Trigger/Marker] and [Head of File] cannot both be set to
"NO".
Playback with the remote control panel is not available
at present. Upgrading is scheduled for the future.
For playback, it is recommended to use the Front-End
application or Back-End Client application.
83