Panasonic AG-CPD20P Operating Instructions Manual page 56

Viewing Live Video
<Detailed Overlay OSD>
<Simple Overlay OSD>
Speed (MPH / km/h)
OWN: Own vehicle speed
Own vehicle speed detected by a Radar or GPS
connected to the recorder is displayed. If the speed data
of both the Radar and GPS are sent from the recorder,
the speed detected by the Radar is displayed.
TGT: Target vehicle speed
Target vehicle speed indication depends on the type of
radar gun that is connected. For example, one ProLaser3
measurement indicates vehicle speed for a period of
about 10 seconds. If another measurement is made within
this 10 second period (approx.), the speed indication is
updated accordingly.
Note:
"ERR" appears to indicate that the radar gun measurement
result is not correct.
Location information (latitude)
Location information (longitude)
Remaining SDHC Memory Card recording time
(HH : MM)
REMAIN: The remaining recordable time
(continued)
LOOP TIME: Loop period (total recording time)
• The remaining recording time is updated about every
30 seconds.
• When Loop recording is set to [ON], loop period (total
recording time) is displayed.
Note:
The total recording time does not include pre-recording and
post-recording time.
Mode indication
: paused : recording
Status display
Displays the status of the recorder and SDHC Memory
Card.
<Status of the recorder>
PON: Power ON recording "ON"
LOP: Loop recording "ON"
INT: Intermittent recording "ON"
<Status Display>
CARD FULL, CARD PROTECT, VUP CARD,
UNFORMATTED, NO CARD, READ ERROR,
UNSUPPORTED, PLAY ERROR
(see "Status Display" on page 118)
56