Remote Control; On/Off Button - Whirlpool SLIM RANGE R22 Instructions For Use Manual

33933049GB.fm Page 9 Monday, January 10, 2005 5:27 PM

REMOTE CONTROL

The remote control transmits signals to the system.
A. ON/OFF button
The appliance will be started when it is energized or will be stopped
when it is in operation, if you press this button.
B. MODE button
Used to select the operation mode.
C. FAN button
Used to select fan speed in sequence auto, high, medium or low.
D. ROOM TEMPERATURE SETTING buttons
Used to select the room temperature.
Used to set time in TIMER mode.
E. SWING button
Used to stop or start vertical adjustment louver swinging and set the
desired up/down airflow direction.
F. 6th Sense button
Used to enter fuzzy logic operation directly, regardless of the unit is on
or off.
G. TIMER SET/CANCEL button
Used to set or cancel the timer operation.
H. SLEEP button
Used to set or cancel Sleep Mode operation.
I. JET button
Used to start or stop the fast cooling.
(Fast cooling operates at high fan speed with 18°C set temp automatically).
Indication symbols on
LCD:
Jet indicator
6th Sense indicator
Sleep indicator
Signal transmit
NOTE: The remote control display continues indicating even when the unit has run down.
How to insert the batteries
Remove the battery cover in the direction of the arrow.
Insert new batteries making sure that the (+) and (-) of battery are
matched correctly.
Refit the cover by sliding it back into position.
NOTE:
Use 2 LR03 AAA (1.5 V) batteries. Do not use rechargeable batteries.
Replace batteries with new ones of the same type when the display
becomes dim.
If the replacement is done within 1 minute, the remote control will keep
original presetting. However, if you want to change the presetting from
Heat Pump to Cool Only or Cool Only to Heat Pump, you should reload
batteries 3 minutes after removing the old ones.
(Please refer to page 5 for details.)
Storage and tips for using the remote control
The remote control can be stored in a holder mounted on the wall.
NOTE: The remote control holder is an optional part.
How to use the remote control
To operate the room air conditioner, point the remote control at the signal
receiver. The remote control will operate the air conditioner at a distance of
up to 7 m when pointing at the signal receiver of the indoor unit.
Choose cooling only remote control or heat pump.
Please refer to page 5 "Preparation before use" for details.
Back-light function (optional)
Please refer to page 5 "Preparation before use" for details.
Auto fan speed
Cooling indicator High fan speed
Dry indicator Medium fan speed
Fan only indicator Low fan speed
*Heating indicator Display set temperature
Display set timer
I
D
E
C
H
Used to regulate
temperature in 6th
Sense mode or Dry
mode (See page 11
"6th Sense mode" for
details)
Remote control holder
Signal receiver
F
B
G
A
9