Interactive Pen Led Guiding Signals - Dell S500 User Manual

Interactive Pen LED Guiding Signals

PEN Status
Normal Mode 1 Pen faces the screen with
Normal Mode 2 Pen doesn't faces the screen
Search for
Open network
mode
Search for Fixed
network mode
Pairing mode
Pair successful
mode
Pair failed mode When pen pair with
Sleep mode
Low battery
capability
Battery is
exhausted and
can not run PB
Battery
charging when
battery low
Battery
charging when
battery full
Downloaded From projector-manual.com DELL Manuals
Description
the link.
but with the link.
When Pen searching for
open network (Green LED
flashing twice every 2 sec).
After holding down Nib and
Function button for 5 secs,
the pen will change to this
mode.
When Pen searching for
fixed network.
After holding down
Function button for 5 secs,
the Green LED will blink 1
time each 0.15 secs
(continued 10 seconds).
When pen pair with
projector successfully after
pairing mode (Green and
Amber LED will flash
alternately continued 3
seconds).
projector failed after pairing
mode (Green and Amber
LED will flash at the same
time continued 3 seconds).
Enter sleep mode for power
saving purpose.
The pen battery is low. Two
hours are left to run out of
the battery.
The Photo sensor and RF
module cannot work
properly. Pen can not work
normal.
Pen put on the charger or
connect USB cable by
Laptop
Pen put on the charger or
connect USB cable by
Laptop
Indicator
Green color Amber color
Solid ON OFF
Flashing 0.02s
OFF
ON /1s OFF
Flashing 0.1s
ON /0.1s OFF
OFF
& 0.1s ON/1.7s
OFF
Flashing 0.3s
OFF
ON /0.3s OFF
Flashing 0.15s
OFF
ON /0.15s OFF
Flashing 0.3s Flashing 0.3s
ON /0.3s OFF OFF/0.3s ON
Flashing 0.3s Flashing 0.3s
ON /0.3s OFF ON /0.3s OFF
Solid ON 3 sec. Solid ON 3 sec.
Flashing 1s
OFF
ON/1s OFF
OFF Solid ON
N/A Solid ON
N/A OFF
Troubleshooting Your Projector
Checking flow and items / times
Will enter Sleep Mode after 3
minutes
If the pen doesn't pair with projector
successfully, the pen will enter Sleep
Mode after 3 minutes
If the pen doesn't pair with projector
successfully, the pen will enter Sleep
Mode after 3 minutes
If the pen pair with projector
successfully, the pen will enter Pair
successful mode.
If the pen doesn't pair with projector
successfully, the pen will enter Pair
failed mode after 10 seconds.
Enter pairing mode and pair
successfully in 10 seconds
Enter pairing mode and pair failed
after 10 seconds
1. Pen doesn't face the screen but
with the link: will enter Sleep mode
after 3 minutes.
2. After searching for AP channel 3
cycles without a link, will enter Sleep
mode.
The MSP430 will check battery
capacity in normal operation. This
alert LED signal is shown if the
battery capacity is low.
The pen battery is exhausted. Power
only works for MSP430. The alert
LED will appear 1 minute to save
power and then enter Sleep mode.
Pen cannot be used in this status.
115