Important Safety Instructions WARNING: Failure to read, thoroughly understand, and follow all instructions can result in serious personal injury, damage to equipment, or voiding of factory warranty! It is the installer’s responsibility to make sure all components are properly assembled and installed using the instructions provided.
Product Dimensions 14.02 in. (356.2 mm) Side View 5.02 in. Front View (127.4 mm) 4.99 in. (126.7 mm) 78.75 in. (2000.1 mm) 80.37 in. (2041.4 mm) 41.60 in. 4.99 in. (1056.5 mm) (984.8 mm) 15.23 in. (386.8 mm) 6.6 in. (167.52 mm) 1.21 in.
Installation 1. Determine desired height of image (measured 4. Determine location of studs behind drywall. from floor) (Figure 1). 5. Drill one pilot hole into a wall stud at location 2. Determine desired center of image area (Figure 1). marked in Step 3 (Figure 1). 3.
Page 6
Wood or steel studs: (3) supplied #8 x 1” screws. Concrete wall or no studs: (3) supplied #8-10 wall anchors and (3) supplied #8 x 1” screws. 11. Install projector mount. Refer to the S520 Dual Figure 3 Stud Wall Mount (MSP-DCCUST2) manual. Do not install the (2) plastic covers for mount (Figure 4).
Page 7
(Figure 8). the supplied #8 x 1/2” screws through bottom brackets into the lower channel of the screen 16. Secure IR sensor bar (packaged with the S520 frame (Figure 7). Projector) to screen by sliding it onto the metal bracket.
Page 8
When secure, route cables and cords behind the Figure 10 two cable cover clips. Attach cable cover to the cable clips (Figure 11). 19. Install projector mount covers and projector. Refer to the S520 Dual Stud Wall Mount (MSP-DCCUST1) manual. Figure 11 Figure 12...
Page 9
Recommended Screen/Whiteboard Recommended Screen/Whiteboard Markers Cleaning This Dell S520 Screen/Whiteboard is a dual-purpose The supplied cleaning cloth can be used to clean projection screen and whiteboard. The surface of marks on the Dell S520 Screen/Whiteboard surface the screen/whiteboard can be used with dry erase made by everyday dry erase marker usage.