3.8.20.2 Get Camera Exposure (
The
'gce'
the camera. The current exposure time is determined by a number of
settings ( see note below ). The camera is capable of measuring the current
exposure time in all modes of operation.
Syntax:
Response:
Example:
Notes:
LYNX Hardware User's Manual
)
'gce'
command returns the measured exposure ( integration ) time of
gce
The current exposure time in units of
i
uSeconds.
User enters command.
gce
Camera responds with current exposure
13333
time.
The measured exposure time is typically the reciprocal
of the current camera speed ( 1/Camera Speed ) unless
the shutter is enabled. If the shutter is enabled, then it
determines the camera exposure time.
The following settings affect the camera's exposure
time:
Single/dual tap mode
Vertical window
Vertical binning
Horizontal center ( IPX-VGA only )
Programmable Frame Rate
Long Integration
Shutter
After issuing a command that affects the camera's
exposure time, the user must wait at least one frame
time before issuing the 'gce' command.
152 of 216