Assembly, Startup, And Dismantling - SignaMax 065-7405TB User Manual

LED
POWER
PWR1
PWR2
(Green)
FAULT
FAULT
(Red)
10/100BaseT/TX
LNK/ACT
(Green)
100
(Yellow)

Assembly, Startup, and Dismantling

Assembly: Place the switch on the DIN rail from above
using the slot. Push the front of the switch toward the
mounting surface until it audibly snaps into place.
Startup: Connect the supply voltage to start up the
switch via the terminal block.
Dismantling: Pull out the lower edge and then remove
the switch from the DIN rail.
State Indication
Switch is properly connected to power and
Steady
turned on.
Switch is not connected to power and is
Off
turned off.
1. Power failure occurred.
Steady
2. Port failure occurred (when port fault alarm
dip switch is enabled).
1. Power failure is not occurred.
2. Port failure is not occurred (when port fault
Off
3. Port fault alarm dip switch is disabled.
or 100BaseFX
A valid network connection established.
Steady
LNK stands for LINK.
Transmitting or receiving data.
Flashing
ACT stands for ACTIVITY.
Light solid yellow for a port transferring at
Steady
100Mbps.
The port is transferring at 10Mbps If this LED
Off
is dark.
alarm dip switch is enabled).
6
Hardened Ethernet Switch