Re-Connection - CipherLab CP60G Reference Manual

CP60 Mobile Computer (CE)

5.3.9. RE-CONNECTION

By default, BT-Connect will automatically re-connect to the previous services the next time
the mobile computer goes through a Bluetooth power cycle. The preferred devices and
services will also be reflected on the Preference tabbed page of
This section explains the statuses of previously connected devices/services and their
re-connection settings.
PREFERRED DEVICE LIST
Tap the Device tabbed page in BT-Connect to check the statuses of previously connected
devices.
Example Device Status
The device has been paired with (
service has been re-connected successfully, such as
Headset/Handsfree, HID, PAN, or SPP.
The device has been paired with (
following
Headset/Handsfree, HID, PAN, or SPP:
(1) Last Connection is set as N, meaning none of the
services are required to be re-connected.
(2) Last Connection is set as Y, but the device fails to be
re-connected.
The device is not paired, yet it has services which do not
require PIN code exchange and are set as not to be
re-connected (such as DUN, FTP, or OPP).
Note: The re-connection settings are configurable via
a specific device from the device list, you have to manually delete records of all its
Bluetooth services on the
158
settings for remote
Preference
) and at least one
) but have the
services, such as
BT Manager. If you want to remove
Tab.
Reference Manual
BT Manager.
Settings in BT-Manager
Last Connection = Y
(on the Preference Tab)
Last Connection = N or Y
(on the Preference Tab)
Last Connection = N
(on the Preference Tab)