CipherLab CP60G Reference Manual page 135

Bit Rate The measurement of how much data is transmitted in a given
amount of time from one location to another.
Radio Mode Use of 802.11a/b/g/n frequencies and data rates when
interacting with an AP, or the use of ad hoc to associate to a
station radio.
Maximum In Max Power Savings (Max PSP) mode, the
access point buffers incoming messages for
the radio, which wakes up periodically and
connects to the access point to see if any
buffered messages are waiting. The radio
requests buffered messages and then goes
back to sleep. It conserves the most power
but offers the lowest throughput. It is
recommended when battery power is in
use.
Fast Power Save Mode (Fast PSP) switches
between the two modes described above,
depending on network traffic. This mode
switches to CAM when retrieving a large
number of packets and switches back to
PSP (= Power Save Polling) after the
packets
recommended when power consumption is
a concern but you need greater throughput
than that allowed by Max PSP.
Default: Fast
Value: Auto (rate is negotiated automatically with the AP)
Default: Auto
Value: B rates only, BG rates full, G rates only, BG LRS, A
rates only, ABG rates full, BGA rates full, Ad Hoc
B rates 1, 2, 5.5, and 11 Mbps.
only
BG rates All B and G rates, plus N rates if supported.
full
G rates 6, 9, 12, 18, 24, 36, 48, and 54 Mbps.
only
BG LRS 1, 2, 5.5, 6, 11, 24, 36, and 54 Mbps. This
should only be used with Cisco APs running
IOS
controllers).
A rates 6, 9, 12, 18, 24, 36, 48, and 54 Mbps, plus
only N rates if supported.
ABG rates All A rates and all B and G rates, with A
full rates (the 802.11a radio) preferred, plus N
if supported.
BGA rates All B and G rates and all A rates, with B and
full G rates (the .11g radio) preferred, plus N
rates if supported.
have been retrieved.
in autonomous mode
Chapter 5 Radios
It is
(without
123