Yamaha YSP-300 Owner's Manual page 60

_-_J_I-'I'IIi'I'IiPI-'I'I'IiI'
• Decoder indicators
Depending on the input source and the selected surround
mode, the decoder indicators in the front panel display
light up as follows:
Status, Indicator
When PCM signals are being input PCM
When DTS digital signals are being
input
When DTS Neo:6 is selected as the
surround mode _ + Neo:6
When Dolby Digital signals are
being input
riD DIGITAL
When Dolby Pro Logic is selected
as the surround mode 13171PL
When Dolby Pro Logic II is selected
as the surround mode rlrl PL II
• You can select an input )node (AUTO, DTS, or ANALOG) by
pressing INPUTMODE repeatedly (see page 87).
• Discs encoded in DTS-ES, Dolby Digital 5.1 EX, Dolby Digital
EX, or Dolby Digital Surround EX will be played back in DTS
or Dolby Digital.
• Input channel indicators
Depending on the channel component of the current
digital input signal, the input channel indicators in the
front panel display light up as follows:
Status I
When 2-channel stereo signals are
being input
When 5. l-channel signals are being
input
[] []
_@_
@ []
r---cg--q
• Surround modes and recommended
sources
Surround mode. source
Dolby Pro Logic
All sources
Movie Movies
Dolby Pro Logic II Music Music
Game Games
Cinema Movies
DTS Neo:6
Music Music
Neural Surround
XM Satellite Radio
(U.S.A. and
Canada models
(U.S.A. and Canada
only) models only)
When you select an input source (see page 45), the surround
)node used for the previously selected input source is
automatically selected.
If the power of this unit is turned off and on again, the surround
)node used for the previously selected input source before the
power was turned off is automatically selected.
[f the surround )nodes are not available, "Prohibit" appears in
the fi'ont panel display when you press SUN. DECODE.
The surround )nodes are available:
- when the beam )node is set to a setting other than the 2-
channel or 5-channel stereo playback (see page 60) and My
Surround (see page 55).
- when the CINEMA DSP programs are turned off
(see page 65).
- when the movie program is selected as the CINEMA DSP
program (see page 64). [n this case, only Dolby Pro Logic,
Dolby Pro Logic II Movie, and DTS Neo:6 Cinema are
available.
- when 2-channel signals are being input.
- when the Music Enhancer is turned off (see page 66).
56
En