Yamaha YSP-300 Owner's Manual page 24

|PI,IIIII:I,'I(I,III _
• Cables used for connections
O HDMIcable
Audio pin cable (supplied)
(Red) (Red)
Optical cable (supplied)
Digital audio pin cable (supplied)
(Orange) (Orange)
3.5 mm stereo mini plug cable
Subwoofer pin cable
O OSD video pin cable (supplied)
(Yellow) (Yellow)
• Notes on connecting the optical cable
• Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put
the cap back in place.
• When inserting the cable into the optical digital jack,
make sure the direction is correct.
Cap
• Affixing cables
To prevent cables from becoming unplugged, place the
supplied cable clamp with the open side facing upward,
attach it to the rear panel of this unit in a suitable position,
and then affix cables in the cable clamp.
__ Optical cable
F Attach to this unit
• Information on HDMI
TM
Audio Signals
DVD video Dolby Digital, DTS, PCM
2-channel stereo
DVD audio
(up to 96 kHz/24 bit)
Blu-ray Disc
HD DVD Dolby Digital, DTS, PCM
• When CPPM copy-protected DVD audio is played back, video
and audio signals may not be output depending on the type of
DVD player.
• This unit is not compatible with HDCP-incompatible HDM[ or
DVI components.
--'4'--
• We recommend that you use an HDM[ cable shorter than 5 m
(16 ft) with the HDM[ logo printed on it.
• Use a conversion cable (HDM[jack _ DVI-D jack) to connect
this unit to other DVI components.
• Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
order: HDMI --+ Digital --+ Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
TV/STB t/ t/
DVD i/ _/
AUX 1 _/ t/ _/
AUX 2 _/
AUX 3 t,/
20 en