Compak RETAIL R140 Instruction Manual page 20

11.4. Reset the burrs to the 0 / Calibration
Position 0 is the point in which the burrs no longer touch.
Following these instructions allows the user to make small adjustments to adapt the
desired particle size for each of the types of coffee referenced on the front control
knob ( ).
• Turn the front dial (
touching.
• Loosen, with the help of the key wrench that comes with the grinder, the screw
(b), until the chain is released.
• Turn the front dial (
• Tighten the screw (b).
• Assemble the upper body (
hopper.
18
) clockwise until the burrs are as close as possible without
) clockwise as far as possible.
), tightening the two rear screws and replace the
ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 30/04/2014 | K04673