Configure H.323 And Sip - Cisco MX series Getting Started Manual

Cisco TelePresence Video Systems

Introduction

Configure H.323 and SIP

(When not set by a provisioning system)
To get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SIP protocol for video calls.
The diagnostics on your system will indicate if there is a
problem with H.323 or SIP registering.
If you wish to change the other H.323 or SIP settings, see the
administrator guide for your product.
For networks administered through Cisco TMS (Cisco
TelePresence Management Suite), your Cisco TMS adminis-
trator will help you to get online.
You can find information about administering through Cisco
UCM in the Administering CE endpoints on CUCM
NOTE: H.323 is not available for the SX10.
If you are changing a value setting,
you have to always click save to confirm the change.
D15318.02 Video Systems Getting Started Guide CE8.1, APRIL 2016.
User interfaces Web interface Web interface
H.323
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the
2. Open the
3. Under the
number in the corresponding input fields.
4. Enter the
field.
5. If the H.323 gatekeeper requires authentication, and you
guide.
want your system to authenticate itself to the gatekeeper,
go to the
the Mode
Password
Otherwise, select
On-screen setup assistant
Setup tab, and select Configuration.
H323 settings from the left sidebar.
H323Alias heading enter the E164 and the
Gatekeeper Address in the corresponding input
Authentication subheading and select
drop down list. Then enter the LoginName
in the corresponding input fields.
Off in the Mode drop down list.
16
Touch
SIP
If in doubt for any of the parameters below, contact your system
administrator or your service provider.
1. Go to the Setup tab, and select Configuration.
2. Open the SIP settings from the left sidebar.
ID 3. Enter the SIP URI in the
display name in the DisplayName
4. Select the preferred transpor t protocol from t h e
DefaultTransport drop down list. If you select Auto, the
system first tries to connect using Tls, then TCP, and finally
UDP.
On in 5. Select a proxy type in the
and type is Standard. You can use
CUCM.
6. Enter the Proxy 1 Address
7. If the SIP proxy requires authentication, you must enter a
login name and password to authenticate your system. Go
to the Authentication heading and enter the
Password in the corresponding input fields.
Copyright © 2016 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Appendices
URI input field, and optionally a
input field.
Type drop down list. The default
Cisco when registering to
in the corresponding input field
LoginName and