Table of Contents
Advertisement
- this fader
»
Independent
is not associated with any
other fader and operates
independently
- is used to select
»
Master
one fader as the master for
group starts.
- is used to select
»
Slave
one or more faders as
Slaves that will follow the
action of the fader that has
been designated as the
Master.
Phone Connection
This section contains the set-
tings for connection to your iQ6
or Telos VX phone system. (Of
course, you can also connect your
iQ to any stand-alone hybrid by
using the inputs and outputs on
the QOR.32, but the settings con-
tained in this section function only
with iQ6 or VX phone systems.)
Note that the iQ phone source
profiles contain settings that are
used to specify individual back-
feeds and hybrid channels for all
types of phone systems.
•
Phone Server IP:
fies your user name and the
IP address of your iQ6 or
Telos VX phone server. Log-
in information is in the for-
mat: user:pass@ip. For ex-
ample, if your VX user name
is Marty and your password
is "C185", you would enter
Marty:C185@192.168.0.123 where 192.168.0.123
is the IP address of your phone server.
•
This is your studio name, as config-
Studio Name:
ured in the VX system.
•
This can be the same as your iQ show
Show Name:
profile for consistency but it must correspond to a
configured in your VX phone system.
Show Name
Speci-
© 2014 Axia Audio - Rev 1.3.1
Figure 4-2: Show Profile Options
If you leave this blank, the current VX show will re-
main in use.
Monitor Section
•
Volume (-85..0 dB):
ume settings for the outputs listed below. The default
setting is full mute:
You may specify initial vol-
Advertisement
Table of Contents
