Table of Contents
Advertisement
13.
Clock and Timer Display:
cludes both the Clock and the Timer. The Clock sec-
tions includes an NTP indicator that tells you when
the iQ synchronized to an external NTP clock refer-
ence. The Timer section displays the count-up timer
that may be controlled by fader-start or by the Timer
controls on the iQ.
14.
If all four bus meters are not set
Meter Key:
for constant display, this toggles the Soft (middle)
meter between Program
and Monitor metering.
15.
Pressing
Clock Key:
this key toggles between
AUTO
and
MANUAL
modes for the count-up
timer. AUTO allows it to
be reset and started by any
source starting that has
it's timer start option en-
abled. MANUAL ignores
those starts and follows the
RUN/STOP/RESET
keys
only. Note that even if you
are set to AUTO, the run/
stop/reset keys still work.
To set the clock, push and
hold the
key for 6
Clock
seconds to enter clock ad-
just mode. The
key
Clock
will illuminate indicating
that clock setup is active.
Release the
key and
Clock
press RUN-STOP to set the clock display forward, and
press RESET to set it back. Press the
to save the current time and exit clock adjust mode.
If NTP is active and enabled (via web page configura-
tion), the time cannot be adjusted manually.
16.
Pressing
Timer Controls:
count-up timer. Pressing the
ally starts or stops the count-up timer. The
This display in-
Figure 3-4: iQ Main - Console Callouts
key again
Clock
zeroes the
RESET
key manu-
RUN/Stop
RUN/
© 2014 Axia Audio - Rev 1.3.1
key illuminates while the timer
Stop
is running
17.
This key allows you to select the
Profile Key:
active iQ Show Profile from a group of four pre-con-
figured profiles. The Studio OLED display tells you
which profile (A, B, C or D) is currently active. The
Studio Monitor knob is used to navigate this screen.
To exit this screen, press the
also push and hold the profile key for 5 seconds to
reload the current profile.
18.
dio" is
other room separate from the
Control Room, such as a talk
studio or news booth. Push-
ing this control selects the
Studio Monitor source; rotate
it to adjust the volume of the
Studio Monitor speakers. Note
that the Studio
monitors
be muted when-
ever any Studio
Microphone is
turned ON.
19.
play:
dicates the volume and source
that is being delivered your
STUDIO monitors. This may
be changed with the
control as described above.
20.
TALK to STUDIO Key:
allows the operator to communicate with all Studio
guests simultaneously. The operator mic is routed
directly to Studio Head-
phone and Studio Moni-
tor outputs while this
key is pressed.
21.
Control
Room
key. You can
Profile
"Stu-
STUDIO:
defined here as an-
will
STUDIO Monitor Dis-
This OLED display in-
STUDIO
This push-to-talk key
Advertisement
Table of Contents
