Table of Contents
Advertisement
the
key while moving the fader up suppresses
Off
turning the channel
On.
•
In
mode, the on/off status and
fader-normal
start/stop commands follow the channel ON/
OFF switches independently of the fader position.
7.
Program Bus Assignment Keys:
nel is assigned to any of the three main output buses
by selecting any (or all) of these program bus keys.
Generally, PGM-1 is the main on-air bus and other
buses are used for produc-
tion or other programming
requirements. All program
outputs are post-fader and
post on-off function.
The fourth bus functions
as a regular output bus, but
any sources feeding PGM-
4 are also sent to a special
bus that can feed a
Record
dedicated recording device,
as well as to the
bus
Phone
that sends mix-minus audio
to any phone callers. These
buses operate independently
but simultaneously, allow-
ing jocks plenty of opera-
tional flexibility.
bus audio output
»
PGM-4
is post-fader, post-ON/
OFF.
bus au-
»
PGM-4 Record
dio output is post-fader, pre-
ON/OFF.
bus audio is sent to callers pre-fader, pre-
»
Phone
ON/OFF.
8.
Channel Options Control:
operates in conjunction with the OLED fader dis-
play. Pushing the rotary encoder selects OPTIONS
mode, displaying various choices on the OLED
beneath. Rotate to select the desired option, and
then push to "take." Once an option has been se-
lected, you can rotate the control again to adjust
the value of that parameter (if any). Press the
key to exit.
In the QOR.32's Web setup, you can also assign a
default function to the rotary encoder. Doing so al-
lows adjustments to fader options, gain trim, input
Each chan-
gain trim, pan, or input selection to be made just by
rotating the knob.
9.
Figure 3-2: iQ Main - Callouts
feed
by
12.
Record:
This control
toring (CR Headphones) will switch from the current
source to the Record Bus, The 3rd meter will display
the Record Bus levels. Control Room Monitors and
Preview speakers will be muted. Pressing a
second time releases
to its previous state.
© 2014 Axia Audio - Rev 1.3.1
Always displays the out-
PGM 1-2 Meter:
put level of the IQ Program 1
bus.
10.
This is a dual function meter.
The left side of this meter al-
ways displays the output level
for the Program 3 bus. The
right side of this meter displays
the output level of a bus that
may be selected by the opera-
tor by using the Meter Select
key (14). Options for this meter
are: PGM 4 or Follow Monitor.
11.
TALK to Backfeed:
key allows the operator to in-
stantly talkback to any phone
or codec source(s) by press-
ing a single key. Pressing
the TALK to Backfeed key
routes the board operator's
mic to all existing backfeeds.
i.e.: you can talk to a codec
or
phone
caller's
simply
pushing
TALK
places the iQ in
Record Mode.
Record Mode
Soft
PGM 3-4 Meter:
This
mix-minus
to
Backfeed.
Moni-
Record
and restores iQ
Advertisement
Table of Contents
