Samsung DS 616 User Manual page 29

MEET ME PAGE AND ANSWER
After a user makes a Meet Me Page, the user may remain off-hook to allow the
paged party to meet the user for a private conversation.
MESSAGE WAITING INDICATIONS
When calling a station and receiving a busy signal or the no answer condition, the
caller can leave an indication that a message is waiting. The message button will
flash red at the messaged keyset. A single line phone will receive a distinctive
message waiting dial tone. Five message waiting indications can be left at any
station.
MICROPHONE ON/OFF PER STATION
The microphone can be disabled at any keyset. When the microphone is disabled,
the keyset cannot use the speakerphone, although on-hook dialing and group lis-
tening are still possible.
MUSIC ON HOLD—FLEXIBLE
The system provides for either an external music on hold device, internally-gener-
ated tones or no music, to be received by stations or C.O. lines placed on hold. If no
service is desired, each station/trunk can be programmed to receive either a 50
ms tone or no music. The system generated tone is a beep every 3.5 seconds.
NIGHT SERVICE
The DS 616 provides separate ringing locations for all trunks in both the day and
the night modes.
AUTOMATIC
Automatic night service allows each tenant to automatically go in and out of night
service according to the system clock. There are separate time options available
for each day of the week. This feature can be overridden by a manual night service
key and passcode.
MANUAL
The operator presses the NIGHT key and then dials a passcode to change day
mode to night mode operation.
OFF-HOOK CALL ALERT
Users may call a busy keyset and offer it another call by sending an off-hook ring
signal. Busy stations may also be alerted to important or emergency calls by re-
ceiving a ring burst each time the DSS key is pressed.
OPERATOR GROUP
The operator group can contain 16 stations to answer incoming calls. Calls to this
group can be set for distributed, sequential or unconditional ringing. Operators
can use the In/Out of Group feature to meet flexible operator requirements.
4.13