Advent ADVUNI300 Operating Instructions Manual page 73

ADVUNI300
SWC Programing
Up to 16 steering wheel control functions can be programmed via the built-
in SWC interface. By default, all SWC functions are set to "Undefined". Not all
functions may be supported for each vehicle.
1. Press key 1 ~ 16, then select a function. The name of the selected function
should appear next to the Key number programmed (Key 1 Volume +,
etc.). Continue selecting a function in this manner until all of the OE
steering wheel control functions are completed.
Note: Functions 1 ~ 16 must be assigned to a function.
For example, if the OE steering wheel does not support Preset + and
Preset -, then these functions must be set to "Undefined" in order for the
other functions to work correctly.
2. To "learn" the "function selection" completed in step 1 above, press the "Learn"
icon. You will then be prompted to push each button on the OE steering wheel (for 1
second), so the unit can learn the corresponding function.
3. SWC learning / programming is now complete.
SWC Programing Screen 1
SWC Programming Screens
SWC Programing Screen 2
73