3-4-3Controller & Ptz Setup - Nadatel N-0441U User Manual

3-4-3CONTROLLER & PTZ Setup
To control the PTZ functions of the camera, connect a controller to the RS-485 port.
①
Connect the RS-485 cables of the PTZ camera to the RS-485 port on the rear panel.
②
Press the PTZ menu button. Then PTZ menu screen is displayed as below.
Note: For speed dome cameras that support RS-485, connect them directly to the RS-485 port. If the camera is
controlled with RS-232C, use a RS-485 to RS-232C signal converter.
On the PTZ control setup screen, you can select or set the protocol type of the camera that is the same as the one
installed on the site. If the camera has a specific camera ID, select the camera ID using the mouse or the control
button of the remote control.
The following options are available on the PTZ setup screen.
CHANNEL (Channel number that the PTZ is connected to)
NAME (Protocol type)
SPEED (Baud Rate) (19200, 14400, 9600, 4800, 2400)
ID (0-63)
Figure 3.4.4. PTZ Control Setup Screen
35 | P a g e