Spot - Out; Ptz Setup - Nadatel SDVR-9000C User Manual

ALARM OUT
SENSOR IN
MOTION ON
VIDEO LOSS ON
ALARM DURATION
3-4-2. SPOT – OUT
Item
SPOT TYPE
SPOT ON EVENT
SPOT EVENT DWELL
TIME
SEQUENCE
SEQ-DWEL TIME
SPOT CHANNEL

3-4-3 PTZ Setup

To control the PTZ functions of the camera, connect the controller to the RS-485 port.
Select alarm from 1 to 4.
Enable setting up to 4 sensors of 9/16 sensors for the each alarm.
Enable setting up to 4 cameras of 9/16cameras for the each alarm.
Enable setting up to 4 cameras of 9/16 cameras for the alarm.
Set the dwell time of alarm from1 to 60seconds.
Figure 3.4.3. SPOT-OUT setup screen
Table 3.4.3. Menu item in SPOT-OUT Setup screen
Select either FULL or QUAD for spot channel display.
Enable/disable spot channel display when event occurred.
Set the dwell time for the display of the event activated channel.
Enable/disable sequential display of spot channel in full screen.
Set the dwell time for spot channel display in sequential display.
Set the channel for spot monitoring.
Description
28