Controller & Ptz Setup - Nadatel UH-0413L User Manual

KEY TONE
REMOTE CONTROL ID
SENSOR
3-4-1 Controller & PTZ Setup
To control the PTZ functions of the camera, connect the PTZ controller to the RS-485 port on the back of
the chassis with CAT5 (or equivalent) cable.
①
Connect the RS-485 cables of PTZ camera to the RS-485 port on the rear panel.
②
Press the Controller & PTZ menu button. Then PTZ menu screen is displayed.
Note: Connect PTZ cameras that support RS-485 directly to the RS-485 port. If the camera is controlled
through an RS-232C interface, use an RS-232C to RS-485 to RS-232C signal converter.
Use the PTZ setup screen to select the following options for the camera PTZ controller:
- CHANNEL: Channel connected to a PTZ device
- CAMERA: Protocol Type
- SPEED: 19200, 14400, 9600, 4800, 2400 (Baud rate)
- ID: 0-63
(9 – Highest sensitivity, 1 – Lowest sensitivity)
Enable/disable key tone from front panel usage.
Set the remote control ID.
1. Select ID.
2. Input the remote control ID number.
3. An icon will indicate on the Live Screen if the remote control
ID is synchronized.
The options are from 0 to 99
Select the type of each sensor.
TYPE Set the type of sensor for the specified channel. Options are:
OFF, N/O (normal open), and N/C (normal closed).
Figure 3.4.1.1. Controller & PTZ Setup Screen
25