Table of Contents
Advertisement
3-4. Setup – Device Mode
In the SETUP menu, select the DEVICE tab. Then, the device menu is displayed as pictured below. Navigate through
the menu items using the mouse or the control button on the remote control and change the value of the menu item.
Item
ALARM OUT
CONTROLLER & PTZ
SPOT-OUT
CHANNEL
MOTION ZONE
MOTION SENSITIVITY
KEY TONE
REMOTE CONTROL ID
SENSOR
TYPE
Figure 3.4.1. Device Mode Setup Screen
Table 3.4.1. Menu Items in Device Setup Screen
Set the sensor, motion, and video loss for each alarm.
Set the PTZ baud rate, protocol, and ID.
Set the all details for spot monitoring. It supports 2 spot-outs.
Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion sensing.
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
Enable/disable key tone.
Select an ID of remote control.
1. Select ID number.
2. Press the same number as ID set in DVR on the remote control.
3. An icon will be displayed on the Live Screen that corresponds to the
remote control ID number.0
The options are from 0 to 99
Select sensor NO from 1 to 4
Set the type of sensor for the specified channel. Options are: OFF, N/O
(normal open), and N/C (normal closed).
Description
33 |
P a g e
Advertisement
Table of Contents
