Messages And Alarms - Expobar ROSETTA MINI CONTROL 1GR User Manual

MESSAgES AND ALARMS

Flowmeter
Gr. X
Time-out alarm
Boiler filling up
Probe unconnect
Service
999999999
Change filter
999999999
If boiler filling time exceeds the programmed time (2 minutes), all of the drink buttons lights will flash and
the machine will be disabled. To re-enable it, turn the machine off and on again at the power switch.
If the electronic control panel does not receive a pulse from the flow meter (coffee too fine or flow meter
fault) within 5 seconds of pressing one of the espresso buttons, the light for the dose selected will start to
flash. To disable it, press the dose button again.
As an additional safety, all dose settings have a maximum dispensing time of 5 minutes.
32
R
Fault in flow meter X
Flow fault detected in counter X
Check that the machine is receiving water.
Temperature sensor fault
Service the machine.
To disable the alarm and reset the counter:
Turn off the machine. Simultaneously press and hold down the
1 short espresso and 1 Long Espresso
Turn on the machine.
Regenerate the filter.
To disable the alarm and reset the counter:
Turn off the machine. Simultaneously press and hold down the
2 Short Espressos and 2 Long Espressos
Turn on the machine.
ROSETTA
buttons.
buttons.