Figure 44 Motion Detection Actions Setup Screen - ADT 4-Channel User Manual

User's Manual
Turning Zone View On will allow you to observe how the DVR is reacting to motion. When in
the motion viewing mode, any detected motion within the zone will be displayed in red.
You can control excessive event logging and remote notification of motions detected after the
motion dwell time by adjusting the motion ignoring dwell intervals. Highlight the box beside
Motion Ignoring Interval and press the
or Never appears. The DVR will not log and notify motion events occurred during the preset
interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring
function.
Highlighting Daytime Setup and pressing the
Highlight the Actions tab, and the Motion Detection Actions setup screen appears.
Figure 44 Motion Detection Actions setup screen.
Highlight the box under the Record heading and press the
You can associate as many cameras with that camera as you wish. If the DVR detects motion on
the selected camera, it starts recording video from all the associated cameras.
NOTE: For the Record action, the camera you select should be set to the Event or Time
& Event recording mode in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the
Output and Beep (DVR's internal buzzer) that you would like to activate and to sound whenever
the DVR detects motion on the selected camera's input.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to
the Event mode in the Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the
On and Off by highlighting Notification and pressing the
items On and Off by highlighting that item and pressing the
the button to accept your changes.
42
button. A list of intervals ranging from 1 to 10 seconds
Highlight the box beside Daytime and press the
Up and Down arrow buttons to set the Daytime range. The DVR will
consider the remaining time range as the Nighttime.
button allow you to set up the Daytime range.
The DVR can be set to react to motion
detection differently for each camera. Each
camera can be associated with another camera,
trigger an Alarm-Out connector, sound the
DVR's internal buzzer, notify a number of
different devices, and/or move PTZ cameras
to preset positions.
NOTE: You can associate multiple cameras
with a camera that detects motion.
button. A list of cameras appears.
button. Select between Alarm
button. You can toggle the entire list
button. You can toggle the individual
button. Highlight OK and press
button. Use the