Figure 23 Rtsp Setup Screen - ADT 4-Channel User Manual

User's Manual
NOTE: You will need to get the IP Address or domain name of the DVRNS Server from your
network administrator.
NOTE: You can use the domain name instead of IP address if you already set up the DNS
Server when setting up the LAN.
Highlight the box beside Port and press the
using the Up and Down arrow buttons to increase or decrease the numbers.
Highlight Enable NAT and press the
NOTE: When using the NAT (Network Address Translation) device, refer to the NAT
manufacturer' instructions for the proper network settings.
Highlight the box beside DVR Name and press the
you to enter the DVR name to be registered on the DVRNS server.
Highlight the Check box and press the
can be used.
NOTE: The DVR name you entered should be checked by selecting Check, otherwise the
DVRNS changes will not be saved.
NOTE: When entering no name or a name already registered on the DVRNS server, an error
message displays.
Highlighting Save and pressing the
DVRNS settings will display the help desk information of the DVRNS server in the box beside
Help Desk.
Highlight the RTSP tab, and the RTSP setup screen displays.
Figure 23 RTSP setup screen.
Highlight the box beside RTP Start Port and press the
the RTP server obtained from your system administrator.
Highlight the box beside RTP End Port and press the
RTP server obtained from your system administrator.
Highlight Use Mobile and press the
can access a remote DVR using a Blackberry or other mobile devices.
28
button. Set the port number of the DVRNS server
button to toggle between On and Off.
button. A virtual keyboard appears allowing
button to check whether or not the name you entered
button registers the DVR on the DVRNS server. Proper
Highlight Enable RTSP (Real-Time
Streaming Protocol) and press the
toggle between On and Off. You will be able
to change the settings if Enable RTPS is
enabled.
NOTE: When selecting Enable RTSP, the
recorded image resolution cannot be set to
Very High during Record setup.
Highlight the box beside RTSP Port and press
the button. Set the port number of the RTSP
server obtained from your system administrator.
button. Set the end port number of the
button to toggle between On and Off. When set to on, you
button. Set the start port number of
button to