Neutral Switch And Dual Eoi Connection - Hyundai Seasall S250S Installation & Operation Manual

INSTALLATION & OPERATION MANUAL
CN8 (KEY SWITCH)
1. Ignition power
2. Start power
3. Permanent power

4. NEUTRAL SWITCH AND DUAL EOI CONNECTION

1) Neutral switch wires should be connected at pin #4 and #5 of the external connector
of the EOI. If there is no neutral switch, jumper #4 and #5 with a short jumper wire.
SYSTEM WITH A NEUTRAL SWITCH
1
4
From neutral switch wiring
2) If there is a dual EOI, you should connect the wiring between #5 (external connector of
the main EOI) and #5 (external connector of the dual EOI)
Main EOI external connector
1
4 5
From neutral switch wiring
!
!
S250 and S220 Series Engines
3
5
8
8
Additional proper wiring needed
FOR USER'S SAFETY, ENGINE WILL NOT CRANK OR START IF GEAR
FOR USER'S SAFETY, ENGINE WILL NOT CRANK OR START IF GEAR
POSITION LEVER IS NOT IN NEUTRAL OR NOT CONNECTED TO THE
POSITION LEVER IS NOT IN NEUTRAL OR NOT CONNECTED TO THE
EOI EXTERNAL CONNECTION.
EOI EXTERNAL CONNECTION.
1
SYSTEM WITH NO NEUTRAL SWITCH
4
Dual EOI external connector
4 5
CAUTION
CAUTION
- 47 -
5
Jumper