HP 100B Maintenance & Serice Manual page 66

6. Disconnect the three cables from the board (2).
NOTE:
pull on the wires.
Figure 6-42
7. Remove the inverter board from the computer.
To remove the inverter board:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the optical drive (see
4. Remove the optical drive bracket (see
5. Remove the tape that secures the cable to the computer.
58 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Be careful not to damage the cables when disconnecting them from the board. Do not
Removing the inverter board
26).
Rear Cover on page
Optical Drive on page
Preparing to Disassemble the Computer
27).
33).
Optical Drive Bracket on page 56).