HP 100B Maintenance & Serice Manual page 76

To remove the WLAN module antenna and cable:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the system board shield (see
4. Disconnect the antenna cable from the module (1), remove the cable from the clips built into the
computer (2), and then lift the antenna from the top of the computer (3).
Figure 6-53
To install the WLAN module cable and antenna, reverse the removal procedures.
NOTE: WLAN modules are designed with a notch to prevent incorrect insertion.
68 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
26).
Rear Cover on page
Disconnecting the WLAN module
Preparing to Disassemble the Computer
27).
System Board Shield on page 63).