Starting Or Joining A Meet-Me Conference Call - Cisco 7920 Phone Manual

If you want to...
Remove any conference par-
ticipant
End your participation in a
conference
Tips
• Calls must be on the same line before you can add them to a conference. If calls are on different
lines, transfer them to a single line before using Confrn or Join.
• Depending on how your phone is configured, if you leave a conference after creating it, the
conference might end. To avoid this, transfer the conference before hanging up.

Starting or Joining a Meet-Me Conference Call

Meet-Me conferencing allows you to start or join a conference by dialing the conference number.
If you want to...
Start a Meet-Me conference 1. Obtain a Meet-Me phone number from your system administrator.
Participate in a Meet-Me
conference
End a Meet-Me conference
36
Then...
1. Highlight the participant's name.
2. Press Remove.
You can remove participants only if you initiated the conference.
Choose EndCall or
Then...
2. Distribute the number to participants.
3. When you are ready to start the meeting, press
then press MeetMe.
4. Dial the Meet-Me conference number.
5. Press the (green key).
Participants can now join the conference by dialing in.
Note Participants hear a busy tone if they call the conference before the
initiator has joined. In this case, participants must call back.
Dial the Meet-Me conference number (provided by the conference
initiator).
Note You will hear a busy tone if you call the conference before the
initiator has joined. In this case, try your call again.
All participants must hang up.
The conference does not automatically end when the conference
initiator disconnects.
(red key).
to see MeetMe,
OL-9474-01